If your hardwood floor has been damaged by water, it is important that you take action to repair the damage. You will want to first clean and mop the area so that you can get all of the water away from the wood. It is best that you remove the furniture as well so that you can get a better idea of what is going on with the wood.

The next thing that you need to do is to use a wet paper towel to wipe off any remaining water that you have left. You also need to make sure that you do not leave the area damp. If you leave damp, the moisture could cause the wood to warp. It is important that you do not use any chemicals when you are trying to repair the damage that has been caused by water.

Now it is time to use sandpaper to help you remove any scratches that you see on your hardwood floor. It is also important that you use the proper sandpaper for the type of wood that you have. If you have hardwood that is stained, you will need to use a different type of sandpaper than if you have a clear wood stain on your floors. Do not try to sand the wood at a lower strength, because you could end up making the damage worse.

Once you have sanded the area you will want to use a liquid adhesive to glue down the new boards that you have installed onto the hardwood. It is important that you do not put any waxes or anything else onto the glue to help protect the wood. It is better to leave the glue dry until the wood has dried out completely.

When the glue has dried, you will be able to remove the flooring from the subflooring that you are working on. Take the flooring that you have removed and lay it flat on top of the flooring that is still on the subflooring. Make sure that you have enough room between the two flooring so that you can install the new boards. You will want to work quickly as you will want to be able to get the flooring in place before water can seep into the wood.

Once you have the flooring in place, you will want to install the new boards to the wood by gluing them together. Do not forget to add a bit of wood glue to each board in order to ensure that they do not snap together when you are installing them. If you accidentally did not buy the right amount. for more info just visit www.charlottehardwoodflooring.net.